This domain name is up for sale. Please send your offer to hostmaster@elatomo.com.

How To: Engine Compression Testing

Here you will find write-ups and other modifications, with pictures and instructions.

Moderators: daewoomofo, Moderators Group

How To: Engine Compression Testing

Postby john_trickle » Sun Feb 04, 2007 8:21 pm

Image

A compression test will tell you if your engine has good compression. An engine is essentially a self-powered air pump, so it needs good compression to run efficiently, cleanly and to start easily.

As a rule, most engines should have 140 to 160 lbs. Of cranking compression with no more than 10% difference between any of the cylinders.

Low compression in one cylinder usually indicates a bad exhaust valve. Low compression in two adjacent cylinders typically means you have a bad head gasket. Low compression in all cylinders would tell you the rings and cylinders are worn and the engine needs to be overhauled.

HOW TO CHECK COMPRESSION

Compression can be checked two ways: manually with a compression gauge, or electronically with an engine analyzer the measures cranking compression. With electronic testing, a computer analyzer estimates compression in each of the engine's cylinders by measuring slight variations in engine cranking speed.

The results correlate well with actual gauge readings, and can be completed in a matter of minutes without having to remove any spark plugs. What's more, the analyzer prints out the results of the compression test making it easy to see and compare the actual numbers.


Image


To check compression manually with a gauge, all the spark plugs must be removed. The ignition coil must then disabled or the high tension lead grounded. If the engine has a distributorless ignition, the ignition coils must be disabled to prevent them from firing. The throttle must also be held open.

The engine is then cranked for a few seconds using a remote starter switch or a helper while a compression gauge is held in a spark plug hole.

The maximum compression reading is noted, then the process is repeated for each of the remaining cylinders.

The individual cylinder readings are then compared to see if the results are within specifications (always refer to a manual for the exact compression figures for your engine because they do vary from

the ballpark figures quoted earlier).

IS IT THE RINGS OR THE VALVES?

If compression is low in one or more cylinders, you can isolate the problem to the valves or rings by squirting a little 30 weight motor oil into the cylinder through the spark plug hole and repeating the compression test. The oil temporarily seals the rings.

If the compression readings are higher the second time around, it means the rings and/or cylinder is worn. No change in the compression readings would tell you the cylinder has a bad valve.

JOHN_TRICKLE
Daewoo Lanos 1.5L SOHC, TD04L @ 8psi
Image
User avatar
john_trickle
Expert
 
Posts: 1011
Joined: Sun Jun 05, 2005 10:04 am
Location: AUSTRALIA

Return to How-To and Modifications

Who is online

Users browsing this forum: No registered users and 1 guest