This domain name is up for sale. Please send your offer to hostmaster@elatomo.com.

How To: Leganza 2.2L timing belt water pump replacement

Here you will find write-ups and other modifications, with pictures and instructions.

Moderators: daewoomofo, Moderators Group

How To: Leganza 2.2L timing belt water pump replacement

Postby azlanos » Sat Jul 09, 2011 12:54 am

Manuel at http://www.justanswer.com/uploads/ebroc ... timing.pdf
2.2L Engine


Disconnect the negative battery cable.
Using a box-end wrench on the drive belt adjuster, turn the adjuster clockwise and remove the drive belt.
From the left rear of the engine compartment, disconnect the 3 electrical connectors from the chassis harness.
Remove the crankshaft pulley-to-crankshaft bolts and remove the pulley.
From the front of the engine, remove the nut and the engine harness cover.
Remove the timing belt cover.
Rotate the crankshaft to position the timing marks at Top Dead Center (TDC) of the No. 1 cylinder’s compression stroke.
NOTE
Mark the rotational direction of the timing belt for reinstallation purposes.
Remove the timing belt tensioner adjusting bolt and the tensioner from the engine.
Remove the timing belt.
Aligning the timing marks and installing the timing belt —2.2L engine
Tensioning the timing belt for a used timing belt —2.2L engine
To install:

Install the timing belt tensioner and finger-tighten the tensioner bolt.
Inspect the timing marks to be sure that the engine is positioned at TDC of the No. 1 cylinder’s compression stroke.
Using tool J-43037, or equivalent, place it between the intake and exhaust sprockets to prevent the camshaft gear from moving during the timing belt installation.
Install the timing belt.
Position the timing belt to ensure that the tension side of the belt is taut and move the timing belt tension adjusting lever clockwise until the tensioner pointer is flowing.
If installing a used timing belt (used over 60 min. from new), the pointer should be positioned approximately 0.16 in. (4mm) to the left of the V notch when viewed from the front of the engine.
If installing a new timing belt, the pointer should be positioned at the center of the V notch when viewed from the front of the engine.
Torque the timing belt tensioner adjusting bolt to 18 ft. lbs. (25 Nm).
Install the timing belt front cover and torque the bolts to 53 inch lbs. (6 Nm).
Install the engine harness connectors.
Install the crankshaft pulley and toque the pulley-to-crankshaft bolts to 14 ft. lbs. (20 Nm).
Move the drive belt tensioner to the loose side and install the drive belt to its normal position.
Connect the negative battery cable.

:ctf:
Last edited by azlanos on Tue Jul 12, 2011 1:29 am, edited 4 times in total.
azlanos
 
Posts: 37
Joined: Sat Jun 19, 2010 2:22 am
Location: surprise, AZ

Re: Leganza 2.2L timing belt water pump replacement

Postby azlanos » Sat Jul 09, 2011 1:00 am

I was looking around for a tutorial on the timing belt replacement on my leganza and didnt find one, so i searched and put this on.

ive done the timing belt and water pump on a 2000 lanos and went great due to the lanos how to, it was very helpfull

add any info / short cuts to make the timing belt job easier for others
azlanos
 
Posts: 37
Joined: Sat Jun 19, 2010 2:22 am
Location: surprise, AZ


Return to How-To and Modifications

Who is online

Users browsing this forum: No registered users and 1 guest